Acorn A5000 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour PC/postes de travail Acorn A5000. 208 - 8-Bit Software [zh] Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Adding External Floppy Disc
Drives to the RISC OS family
of machines.
This application note describes how to fit external 3.5" or 5.25" floppy disc drives to the RISC
OS family of machines. It also describes the types of disc format supported by a particular drive
when using RISC OS 2 and RISC OS 3.
NOTE: New A3000/A4000 series computers cannot be fitted with an extra floppy disc
drive (see section 4).
Applicable
Hardware :
A5000 series
A3000
A300 series
A400 series
A440
A540
Support Group
Acorn Computers Limited
Acorn House
Vision Park
Histon
Cambridge CB4 4AE
Related
Application
Notes:
Copyright © Acorn Computers Limited 1992
Every effort has been made to ensure that the information in this leaflet is true and correct at
the time of printing. However, the products described in this leaflet are subject to continuous
development and improvements and Acorn Computers Limited reserves the right to change
its specifications at any time. Acorn Computers Limited cannot accept liability for any loss
or damage arising from the use of any information or particulars in this leaflet. ACORN,
ECONET and ARCHIMEDES are trademarks of Acorn Computers Limited.
All trademarks are acknowledged.
None
13th October 1992
Support Group Application Note
Number: 208
Issue: 2.0
Author: Russell Scott
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Drives to the RISC OS family

Adding External Floppy DiscDrives to the RISC OS familyof machines.This application note describes how to fit external 3.5" or 5.25" flop

Page 2 - Contents

Contents1 Introduction2 RISC OS 3 machines2.1 Supported disc formats3 A5000 series3.1 Floppy disc interface3.2 Drive/Format chart3.3 How to fit an ext

Page 3 - 3.1 Floppy disc interface

1.0 IntroductionThis application note describes how to connect external 3.5" or 5.25" floppy disc drives to the RISC OSrange of machines.

Page 4 - 3.2 Drive/Format chart

Two DRIVE SELECT signals (0 and 1) are provided on this connector. The internal floppy disc drive(s) arefitted to this connector.Connector B (PL11)Thi

Page 5

3.3 How to fit an external driveDisassembly1) Safety Warning! Switch off and disconnect the computer from the mains supply, then switch offand dis

Page 6 - 5.1 Supported disc formats

4.0 New A3000/A4000 series4.1 Floppy disc interfaceThough the floppy disc controller hardware in the new A3000/A4000 is essentially the same as th

Page 7 - A440/1 etc

If you have an external 5.25" floppy disc drive then the following formats are also supported:DOS 360K without additional software (e.g. !MultiFS

Page 8 - 6.0 Appendix

6.0 AppendixThe following third parties supply a combination of the products discussed in this application note:DFS Reader DFS ReaderDisc Buffer Car

Commentaires sur ces manuels

Pas de commentaire